If the treadmill jerks at startup/use (running fast/slow in speed), the setting
on the treadmill needs to be changed. This is done using the guide below. For each image there is a text;
follow these steps and the treadmill should hopefully function normally again after adjusting this.
Step 1:
The magnet must be removed from the start!
Now hold both INCLINE (↑↓) buttons
simultaneously and place the magnet on
in the meantime. A beep sound will now occur.
Step 2:
A text will now appear on the screen, showing
SI. Then the numbers 100/0 will be displayed.
You can now remove your fingers from the INCLINE (↑↓) buttons.
Step 3:
Now press the green start button until the numbers change to 105/25.
(This requires pressing the green button about 5 times.)
Step 4:
The numbers now need to be changed.
This is done by pressing the SPEED MINUS (-) button.
The number 25 should be changed down to 15.
The number 105 remains the same.
Step 6:
Use two fingers to press both SPEED buttons (-+) simultaneously.
Just a single press and a beep sound will occur.
Step 7:
Now remove the magnet.
A long beep sound will occur.
Step 8:
Place the magnet back on.
The setting is now changed and the treadmill and speed will function normally again.
Related to: